Installation Of The Battery; Check The Radio System; Getting Started - MODSTER Vector SR65 Manual

Manual - Vector SR65

Installation of the Battery

1. Turn the hatch of the fuselage clockwise to unlock the door.
2. Open the hull cover.
3. Attach the enclosed tape or Velcro tape to the battery.
4 & 5. Fasten the battery with the hook strip in the boat and fix it as shown.

Check the Radio System

WARNING: Always keep all parts of your body, hair and loose or suspended parts away from
the propeller as they can get caught.
Always turn on the transmitter before the ESC. Also turn the ESC off before the transmit-
ter. Never transport the battery while still connected to the ESC.
1. Set the transmitter throttle and the trim to the center position.
2. Turn on the transmitter.
3. Connect a fully charged battery to the ESC.
4. Check that the vehicle is moving in the right direction when you are steering right or left.
5. Give maximum throttle, then move the throttle lever in the opposite direction, the pro-
peller should now turn in the other direction. The ESC auto-sensing voltage cutoff is used
when the ESC detects a low battery level. Release the throttle and recharge the battery if
necessary.

Getting Started

1. Turn on the transmitter.
2. Connect a fully charged battery to the controller.
3. Test transmitter's control with the boat on the display stand.
4. After you carefully place the boat into the water, start driving slowly. If the boat does not go
straight, adjust the trim on the transmitter.
5. Turn the controller off and disconnect the battery.
6. Always turn off the transmitter at the end.
7. Allow the motor, the ESC and the battery to cool before recharging or reusing the boat.
www.modster.at 19