Betriebsanleitung - T-33 Inhaltsverzeichnis Warnung........................................3 Sicherheitsvorkehrungen................................3 Einleitung........................................4 Spezifikationen.......................................4 Inhalt des Kits......................................5 Montage........................................5-6 Installation der Batterie..................................6 Empfänger-Diagramm..................................6 Check vor dem Flug....................................7 Einstellungen von Steuerhorn und Servoarm........................8 Schwerpunkt finden...................................8 Bevor Sie das Modell fliegen.................................9 Flug Kurs........................................10 Fehlerbehebung....................................11 Gewährleistungsauschluss................................12 Konformitätserklärung...................................25 www.modster.at...
Lecken Sie niemals an Teilen des Modells oder nehmen Sie diese in den Mund, da dies zu schweren Verletzungen oder sogar zum Tod führen kann. • Bewahren Sie alle Chemikalien, Kleinteile und alle elektrischen Geräte außerhalb der Reich- weite von Kindern auf. www.modster.at...
Loch geführt wird. Hinweis: Kabel nicht quetschen.. Einbau des Höhenleitwerks 1. Bringen Sie das Höhenleitwerk mit 2. Bringen Sie die Schubstange wie Schaumstoffkleber am hinteren Teil abgebildet am Steuerhorn des Hö- des Rumpfes an. henleitwerks an. www.modster.at...
Die Kabel von der Servoanschlussplatine sollten in der in der gezeigten Reihenfolge an den Empfänger angeschlossen werden. Beachten Sie, dass die LEDs von jedem freien Kanal des Empfängers gespeist werden können. Stecken Sie die Kabel in die Vertie- fung auf der Rückseite der Akkuklappe. www.modster.at...
8mm auf / ab Sie sich, dass das Modell in einer angemes- senen Höhe und Geschwindigkeit fliegt, Höhenr. 10mm auf / ab 8mm auf / ab bevor Sie hohe Raten verwenden, da das Flugzeug bei größeren Ruderbewegungen empfindlich auf Steuereingaben reagiert. www.modster.at...
Verschieben des Akkus an eine geeigne- te Stelle nicht erreichen, können Sie auch ein Gegengewicht einbauen, um den korrekten Schwerpunkt zu erreichen. Bei der empfohle- nen Akkugröße ist ein Gegengewicht jedoch nicht erforderlich. Wir empfehlen, ohne unnöti- ges Gegengewicht zu fliegen. www.modster.at...
Gasknüppel ein paar Sekunden lang ganz unten gehalten wird. Um eine unerwartete „‘‘dead stick‘‘-Landung“ bei Ihrem ersten Flug zu vermeiden, stellen Sie Ihren Timer auf konservative 4 Minuten ein. Wenn Ihr Alarm ertönt, sollten Sie sofort landen. www.modster.at...
CA und 5-Min-Epoxid durchgeführt werden. Wenn Teile nicht repariert werden können, sehen Sie in der Ersatzteilliste nach, um sie nach Artikelnummern zu bestel- len.Überprüfen Sie immer, ob alle Schrauben am Flugzeug fest angezogen sind. Achten Sie besonders darauf, dass der Spinner vor jedem Flug fest sitzt. www.modster.at...
Empfänger, Regler, Mo- • Regler verwendet standardmä- tor & Verkabelung auf Schä- Motorleistung pul- ßig eine weiche Niederspan- den (bei Bedarf ersetzen). siert, dann verliert nungsabschaltung (LVC). • Das Flugzeug sofort landen Motor die Leistung. und den Flugakku aufladen. www.modster.at...
7. Trennen Sie nach dem Flug immer den Akku vom Modell und entnehmen diesen. 8. Laden und lagern Sie den Akku immer außerhalb des Modells und auf unbrennbarem Untergrund. Niemals im Modell laden! Niemals den Akku unbeaufsichtigt laden! Informieren Sie sich über die in Ihrem Land gültigen, gesetzlichen Bestimmungen. www.modster.at...
Page 14
Introduction......................................16 Specification......................................16 Kit Contents......................................17 Model assembly.....................................17-18 Battery Installation.....................................18 Receiver Diagram....................................18 Preflight Check.....................................19 Control horn and servo arm settings............................20 Finding the center of gravity..............................20 Before flying the model..................................21 Flying course......................................22 Troubleshooting Guide...................................23 Spare Parts......................................23 Disclaimer of Warranty...................................24 Declaration of Conformity................................25 www.modster.at...
Avoid cleaning this product with chemicals. • Never lick or place any part of your model in your mouth as it could cause serious injury or even death. • Keep all chemicals, small parts and anything electrical out of the reach of children. www.modster.at...
Note: Do not squeeze the wire leads. Horizontal stabilizer installation 1. Install the horizontal stabilizer to 2. Install the pushrod to the control the rear of fuselage using foam safe horn on the horizontal stabilizer as glue. shown. www.modster.at...
The cables from the servo connector board should be connected to your receiver in the order shown. Note that the LEDs can be powered by any spare channel on the receiver. Tuck the wire leads into the recessed cavity towards the rear of the battery hatch. www.modster.at...
8mm up / down flying at a decent altitude and speed prior to using high rates, as the aircraft will be Aileron 10mm up / down 8mm up / down sensitive to control inputs with the larger control surface movements. www.modster.at...
If you cannot obtain the recommended CG by moving the battery to a suitable location, you can also install a counterweight to achieve correct CG. However, with the recommended battery size, a counterweight is not required. We recommend flying without unnecessary counterweight. www.modster.at...
Often (but not always) power can be briefly restored after the motor cuts off by holding the throttle stick all the way down for a few seconds. To avoid an unexpected dead-stick landing on your first flight, set your timer to a conservative 4 minutes. When your alarm sounds you should land right away. www.modster.at...
5min epoxy. When parts are not repairable, see the spare parts lst for ordering by item number.Always check to make sure all screws on the aircraft are tightened. Pay special atten- tion to make sure the spinner is firmly in place before every flight. www.modster.at...
Loss of power to aircraft. transmitter, receiver, ESC, Motor power • ESC uses default soft Low motor and wiring for damage pulses then motor Voltage Cutoff(LVC). (replace as needed). loses power. • Land aircraft immediately and recharge flight battery. www.modster.at...
7. Always disconnect and remove the flight battery from the model after the flight. 8. Always charge and store the battery outside of the model, charge on a non-flammable surface, never store the battery in the model. Never charge batteries unobserved! Check about the legal provisions applicable in your country www.modster.at...
Need help?
Do you have a question about the HOBBY ARROWS T-33 and is the answer not in the manual?
Questions and answers