Furniture of America CM7661Q Assembly Instructions
  1. Manuals
  2. Brands
  3. Furniture of America Manuals
  4. Indoor Furnishing
  5. CM7661Q
  6. Assembly instructions

Furniture of America CM7661Q Assembly Instructions

Hide thumbs Also See for CM7661Q:
1
2
3
4
5

Advertisement

Table of Contents

For more information contact our team: service.ec@foagroup.com

ASSEMBLY RATING

The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
EASY
CM7661Q
DIFFICULT
Tools Required For Assembly:
Allen Wrench
Wrench
Phillips Screwdriver
2 PERSONS RECOMMENDED
Page 1 of 5
(Included)
(Included)
(Not Included)
Rev: 18-01-06

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CM7661Q and is the answer not in the manual?

Questions and answers

Related Manuals for Furniture of America CM7661Q

Summary of Contents for Furniture of America CM7661Q

  • Page 1 Assembly Instructions For more information contact our team: service.ec@foagroup.com CM7661Q ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that Allen Wrench shows the degree of effort needed in (Included) assembling a specific product (with 1 being Wrench easy and 5 being difficult).
  • Page 2 LOOSEN OVER TIME AND MAY CAUSE THE FURNITURE TO BE WOBBLY AND UNABLE TO SUPPORT ITS INTENDED WEIGHT CAPACITY. THIS MAY LEAD TO COLLAPSE AND MAY CAUSE SERIOUS INJURY. FAILURE TO FOLLOW THE GUIDELINES ABOVE MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE. FURNITURE OF AMERICA.ALL RIGHTS RESERVED. Page 2 of 5...
  • Page 3 Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. #1 x 1pc #A x 8pcs Headboard Bolt Ø5/16" x 2-1/4" #B x 10pcs #2 x 2pcs H/Board Leg (R/ L) Bolt Ø5/16"...
  • Page 4 DO NOT FULLY TIGHTEN BOLTS UNTIL ALL BOLTS ARE IN. #A x 8pcs Align HB legs (#2) to the holes of the headboard #B x 10pcs (#1), then secure by using bolts (#A,B). Align HB #C x 18pcs leg rail (#3) to the holes of the HB legs (#2), then #D x 18pcs secure by using bolts (#B).
  • Page 5 Attach support legs (#7) to the holes of the slats (#6). Adjust leveler of the support legs (#7) according to ground level. Align slats (#6) to the side rails (#5), then secure by using screws (#I). #I x 6pcs Page 5 of 5...

Table of Contents