Pc Based Feature Programming / Firmware Updates (Optional) - Code Alarm PROFESSIONAL Series Installation Manual

Feature Bank 3 - 5 Chirps
Output Control
1 Lock / Unlock Timing
Factory Disarm
2
Lt Green / Black
3 Ignition Locks
4 Trunk Output Timing
5 Horn Output Timing
6 Real Panic
AUX 1
7
Violet / Black Output

PC Based Feature Programming / Firmware Updates (optional)

When using the NEW Code Alarm Utility App along with a VEPROG Programming
tool you may program selectable features or update the firmware of this module.
To Use a PC and VEPROG tool for Feature Programming or Firmware Updates:
1. Download and install the Code Alarm Utility App. from the Voxx Tech / Software
Downloads section of voxxuniversity.com (login required)
2. Launch the Code Alarm Utility App.
3. Connect the VEPROG to your PC via the USB port.
4. Connect the VEPROG to the Code Alarm Module.
5. Select the features you wish to change or update firmware if needed.
2020 Voxx Electronics Corporation. All rights reserved.
1 LED Flash 2 LED Flash
3.5 Sec.
1 Sec.
Factory
2nd Unlock
Disarm
OFF Lock / Unlock
1 Sec. 10 Sec.
16mS 10mS
ON OFF
Push and
Latched
Hold
3 LED Flash 4 LED Flash
1 Sec. Lock, 30 Sec. Lock,
2x Unlock 2x Unlock
Factory Disarm Factory Disarm
2x 500mS 350mS
Lock Only Unlock Only
Latched until
20 Sec.
IGN ON
30mS 40mS
Latched until Dome Light
IGN ON Output
5 LED Flash 6 LED Flash
2x Lock,
0.5 Sec.
1 Sec. Unlock
Factory Disarm
Factory Disarm
w/ Unlock
500mS
Timing
Latched ON
until Button
Press
50mS
15