Bosch WAU28PH9GB User Manual And Installation Instructions page 47

Fault
"E:30/-20"
The appliance is not
working.
The programme does
not start.
Cause and troubleshooting
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 56
Detergent dosage is too high.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
▶
is operating.
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed
Press .
▶
Door is not closed.
Close the door.
1.
Press to start the programme.
2.
Childproof lock is activated.
→ "Deactivating the childproof lock", Page 33
▶
/ is activated.
Check whether
▶
→ "Buttons", Page 23
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press to start the programme.
4.
The detergent drawer has not been pushed in as far
as it can go.
Push the detergent drawer in as far as it will go.
▶
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 40
.
/ is activated.
Troubleshooting en
47