Advertisement
D
G
H
Fig. 35
5.
Support the duplicator at both ends while sliding mounting pad (D) Fig. 35 along the duplicator rail. Slide until the tapped hole
in mounting pad (D) lines up with the slot in mounting bracket (F), and fasten with M16 x 35mm hex socket head screw and flat
washer (G) using supplied 14mm hex wrench (H).
6.
Tighten two hex nuts (one of which is shown at (E) Fig. 36, socket head bolt (G) and hex head bolt (J). Final adjustments
will be made later.
7.
Mount the duplicator assembly (C) Fig. 37 to mounting bracket (F) on the other end of the lathe in the same manner.
IMPORTANT: Tighten all mounting hardware.
8.
Replace tailstock.
ATTACHING HANDLE ASSEMBLY TO CARRIAGE
1.
Loosen and remove hex nut (A) Fig. 38, two flat washers (B) and stud (C)
from handle assembly (D). IMPORTANT: Remove wing nut (E) to loosen one
end of spring (F).
2.
Thread stud (C) with a flat washer (B) Fig. 39 (removed in STEP 1) to left
side of carriage assembly (E).
3.
Loosen and remove hex nut (G) Fig. 39, and one flat washer (H) from stud
of carriage assembly (E).
4.
Attach handle assembly (D) Fig. 40 on studs (C) and (K). Fasten with hex
nuts (A) and (G) and flat washers (B) and (H) (removed in STEPS 1 and 3).
5.
Attach free end of tension spring (L) Fig. 41 through the hole in end of
threaded rod (M). Carefully apply tension to spring (L) and insert end of thread-
ed rod (M) through hole in lip of handle assembly (D). Fasten with flat washer
and wing nut (E) (removed from handle assembly (D) in STEP 1). Correct spring
tension is determined by the operator and can be adjusted later.
ATTACHING HANDLES TO CARRIAGE SHAFT
1.
Thread four handles (J) Fig. 42 into hub (K) of carriage shaft (L)
B
A
C
G
K
Fig. 40
F
E
J
D
H
L
K
M
G
Fig. 36
.
D
G
Fig. 41
8
C
Fig. 37
D
A
C
Fig. 38
C
B
E
G
H
Fig. 39
J
L
K
Fig. 42
F
F
E
B
Advertisement
