Page 2
Slide carriage (G) Fig. onto duplicator guide rail (C) by engaging two guides into channels and sliding carriage (G) into gear rack (K). Replace belt guide and screw that were removed in STEP 1 to right side of duplicator rail (C). Fig.
Page 3
Assemble loose end of belt Fig. around guide on left side of rail (C), under lip (M) of guide rail and fasten to side of carriage (G) by repeating STEPS belt Fig. ASSEMBLING PATTERN SUPPORT BRACKETS TO DUPLICATOR RAIL Slide pattern support bracket (A) Fig. 9, into bottom channel of duplicator rail and tighten two screws (C).
Page 4
ASSEMBLING HANDLE ASSEMBLY TO CARRIAGE Loosen and remove hex nut (A) Fig. 19, two flat washers and stud (C) from handle assembly (0). IMPORTANT: It may be necessary to remove wing nut (E) and remove one end of spring (F) to assemble handle to carriage assembly.