Advertisement
FOR MODEL 40-860 16" WOOD LATHE ONLY!
10. Move duplicator carriage (N) Fig. 60 to the left until the cutting tool is in the same plane as headstock center. Loosen two
socket head bolts (S) and (T) Fig. 60, and slide duplicator in or out until point of cutting tool (P) Fig. 61 is aligned vertically (up
or down) with point of headstock center (O). Snug-up socket head bolt (T) Fig. 60.
A.
Move duplicator carriage (N) Fig. 60 to the right until point of cutting tool (P) is in the same plane with point of tailstock
center (U) Fig. 62. Slide duplicator in or out until point of cutting tool (P) is vertically on the same plane with point of tail-
stock center (U).
B.
Snug-up socket head bolts (T) Fig. 60. Recheck for alignment between the point of cutting tool vertically with the head-
stock and tailstock centers and tighten two socket head bolts (S) and (T) Fig. 60.
C.
Move carriage assembly (N) Fig. 60 to the headstock until the point of cutting tool (P) Fig. 61 is on the same plane (up
or down) with headstock center (O) Fig. 60.
D.
If the point of cutting tool (P) Fig. 61 is above or below the headstock center (O), loosen socket head bolts (W) and (X)
Fig. 60, and loosen locknuts (V) Fig. 63. Turn leveling screw (S) Fig. 60 clockwise or counter-clockwise to raise or lower
cutting tool until the edge of cutting tool (P) Fig. 61 contacts headstock center (O).
E.
Move carriage assembly (N) Fig. 62 to the tailstock until the point of cutting tool (P) is on the same plane (up or down)
with tailstock center (U).
F.
If the point of cutting tool (P) Fig. 62 is not contacting tailstock center (U), turn leveling screw (T) clockwise or counter-
clockwise to raise or lower cutting tool until the edge of cutting tool (P) Fig. 62 contacts tailstock center (U).
G.
Recheck for contact between the point of cutting tool and the headstock and tailstock centers. Readjust if necessary.
H.
Firmly tighten locknuts (V) Fig. 63, and tighten bracket holding screws (W) and (X) Fig. 60.
X
S
N
N
W
T
Fig. 60
U P
Fig. 62
P
N
12
O
Fig. 61
V
S
T
Fig. 63
Advertisement
