Advertisement
ALIGNING DUPLICATOR TO THE LATHE
For All Delta Wood Lathes
1.
DISCONNECT THE MACHINE FROM THE POWER SOURCE.
2.
Install centers in headstock and tailstock.
3.
Ensure that cutting tool (A) Fig. 47 is approximately 1" out from tool holder
(B).
4.
Point the follower arm lever (C) Fig. 48 to the right, and tighten wing screw
(D).
5.
Pull back handle (F) Fig. 49, and push positioning lever (E) forward all the
way. Move handle (F) forward as far as possible. The tool holder (G) will then be
in the full outward position. IMPORTANT: Do not move cutting tool holder (G) in
or out any further until duplicator is aligned with the lathe.
6.
Loosen two screws (H) Fig. 50, and slide bracket (J) to the left until it is flush
with the left edge of rail (K). Tighten two screws (H).
7.
Turn knob (L) Fig. 50 counterclockwise to move point of screw (M) to the
left, out of the way.
D
Fig. 48
8.
Move carriage (N) Fig. 51, of duplicator toward the headstock until point of cutting tool (P) is in the same plane with point
(O) of headstock center.
9.
Turn knob (L) Fig. 52 clockwise until point of screw (M) is contacting rear portion of follower arm (C). IMPORTANT: If nec-
essary, turn fine-adjustment knob (R) right or left to adjust.
P
N
C
E
G
O
Fig. 51
F
Fig. 49
L
10
Fig. 47
K
H
J
L
Fig. 50
R
c
M
Fig. 52
B
A
M
Advertisement
