Advertisement
DUPLICATING FROM A TEMPLATE
Determine the center line of the turning on the template (A) Fig. 84. A minimum of 3" from the center line to the back edge of
the templet (A) will give maximum support to the template (A) when installed on the duplicator (B).
When attaching the template (A) Fig. 84 to the duplicator (B), the back edge of the template should rest on the ledge of the
channel (C) and the two support brackets (not shown) should be positioned under the template (A) for additional support.
The center line of the template (A) Fig. 85, which is determined by the diameter of the finished piece, should be set directly over
the center pins of the pattern support brackets (D) and fastened in position with four screws supplied. NOTE: After a test cut,
minor adjustments can easily be made to the placement of the template (A) on the pattern holding brackets (D).
B
PARTS, SERVICE OR WARRANTY ASSISTANCE
All Delta Machines and accessories are manufactured to high quality standards and are serviced by a network
•
of Porter-Cable
Delta Factory Service Centers and Delta Authorized Service Stations. To obtain additional
information regarding your Delta quality product or to obtain parts, service, warranty assistance, or the loca-
tion of the nearest service outlet, please call 1-800-223-7278 (In Canada call 1-800-463-3582).
C
A
Fig. 84
A
D
17
17
D
Fig. 85
Advertisement
