Advertisement
ATTACHING MOUNTING BRACKETS
For Delta Models 46-860 16", 46-745 16" & 46-715 14" Wood Lathes Only
1. Thread M8 Hex Nut (A) Fig. 3 on M8 X 55mm Socket Set screw (B).
NOTE: Do not install (A) or (B) Fig. 3 when using the model 46-715 or the model 46-745. Discard the nuts and set aside
the screws for further use. (See"ATTACHING DUPLICATOR TO WOOD LATHE" in this document).
2. Thread the socket set screw (B) Fig. 3 with hex nut (A) into the tapped hole in both mounting brackets (C).
NOTE: To make installation easier, adjust the screws so they are equal in length, then tighten hex nuts (A) against the
bottom of mounting brackets (C).
3. Position clamping plate (D) Fig. 4 under mounting brackets (C) and fasten with two M12 x 45mm hex
socket head screws (E) and
Remove tailstock from the machine.
4. Insert clamping plate (C) Fig. 5 of mounting bracket assembly (D) into channel on tailstock end of lathe bed. NOTE:
Loosely tighten hardware (E).
5. Slide the remaining mounting bracket assembly (C) Fig. 6 onto the lathe bed at the headstock end of the wood
lathe. Move it to about one inch from the end of the lathe bed. NOTE: Loosely tighten hardware (E).
C
A
B
Fig. 3
For Delta Model DL-40 16" Wood Lathes Only
1. Thread M6 Hex Nut, one of which is shown at (A) Fig. 7 on M6 x 30 hex head screw (B) and thread the hex head screw
(B) into mounting ledge (C) at the front of the lathe bed. Similarly, thread the remaining M6 x 30 hex head screw with lock-
nut to the mounting ledge on the other end of the lathe bed in the same manner. NOTE: To make the installation easier,
adjust the two hex head screws (B) Fig. 7 so the tops of screws (B) are equal to each other in length. Tighten hex nuts (A)
Fig. 7 against ledge (C).
2. Attach the two mounting brackets (D) Fig. 8 to the front of the lathe bed, and fasten with two
M16 x 35mm hex socket head screws (E) and two flat washers (E). NOTE: Rest the bottom of mounting brackets (D)
on top of hex head screws (B).
C
E
Fig. 6
flat washers (F). Tighten screws just enough to hold assembly together.
16mm x 41mm
C
D
D
C
F
E
Fig. 4
B
A
C
Fig. 7
3
C
E
D
Fig. 5
D
E
B
Fig. 8
Advertisement
