Auto-Restart Function; Control Panel - Bosch AutoCook MUC6 Series Instruction Manual

Auto-Restart function

The appliance has an "Auto-Restart"
function. Whenever the power supply fails
or is interrupted by the user, the appliance
will automatically return to the last
programme used once it is supplied with
sufficient power again or is reconnected to
the power supply. The appliance will start to
heat up again, and the display will show the
remaining time for the resumed programme.
W Risk of fire!
Never plug the appliance in if there are still
accessories or other objects in the pan.
After plugging in, always check whether a
programme is run automatically.
If an unwanted programme starts running,
press button H to stop the programme and
to enter standby mode.

Control panel

X Figure C
The control panel consists of controls
(buttons) and indicators (LEDs). The
buttons can be used to select the individual
preparation programmes and adopt the
different setting options (e.g. to select
steam pressure function, preparation
temperature / time). The settings are
indicated via the illuminated LEDs and/or
the display.
Controls
B
Standby
Switches from standby mode to
function selection mode and back
again.
A
Set the start time delay
The start time delay can be set for
the selected preparation programme.
D
Select a preparation programme
from the list (h)
The individual preparation
programmes are displayed one
after another by repeatedly pressing
button D. The corresponding LED
lights up in the control panel.
Auto-Restart function
E
Adjust the preparation time
The pre-configured preparation time
[ средняя ] (medium) for a preparation
programme can be shortened
[ короткая ] or lengthened [ длинная ].
The corresponding indicator (g) lights
up. The corresponding pre-configured
preparation time is shown in the
display (a).
F
Set a customised preparation time
For customised adjustment of the
preparation time.
C
Set a customised preparation
temperature
For customised adjustment of
the preparation temperature.
For preparation programmes with
enabled steam pressure function, the
temperature is pre-configured (f) and
cannot be adjusted individually.
L
Steam pressure function
The steam pressure functions
"low steam pressure" [ K ] or
"high steam pressure" [ L ] are
selected by pressing button L.
The respective indicators (f) light up.
X "Preparation with steam pressure"
see page 15
G
Confirm the programme
Pressing button G starts the
selected preparation programme.
H
Delete a setting or abort the
programme
Pressing button H deletes the
settings or stops a programme that
was previously started.
Indicators
a Display
Display of the remaining time or the
temperature.
b таймер (timer)
Indicates that the start time delay is
enabled. The display (a) shows the time
until the start of the selected preparation
programme.
en
9