Overload Protection; Speed Setting; Reversing Function - Bosch CompactPower MFW39 Series Instruction Manual

en

Overload protection

All models
Operation indicator
The operation indicator lights up when the
appliance is switched on. On models with
the reversing function the function indicator
flashes for as long as the + button is
pressed.
Release button
Press the release button to unlock an
attachment fitted on the appliance. Only
when the release button is pressed is it
possible to turn the attachment clockwise
and remove it from the base unit.
Cable storage compartment
The mains cable can be pulled out of the
cable storage compartment or pushed back
in again. Only ever pull the cable out as
much as is required.
Storage compartment
Unused perforated discs belonging to the
meat mincer can be kept in the storage
compartment and it closed with the cover.
Overload protection
To prevent serious damage to your
appliance if the base attachment is
overloaded, the agitator paddle has a
notch (predetermined breaking point). If
overloading occurs, the agitator paddle
will break at this point. A new agitator
paddle is available from Customer
Service (No. 10005188). Spare parts with
a predetermined breaking point are not
covered by our warranty obligations.
Replace agitator paddle
X Fig. B
1. Release the screw in the agitator paddle
with a screwdriver (PH2) and remove
the faulty paddle.
2. Fit a new agitator paddle and screw tight
again.
30
MFW39_EU_8001252225.indb 30 MFW39_EU_8001252225.indb 30

Speed setting

ONLY MFW3X...
Using the speed setting feature, the speed
can be set to 1 (slow) or 2 (fast).
Caution!
For certain applications, it is imperative
to use speed 1 (slow). Take note of the
recommended speeds! See table X Fig. P
■ Switch on the appliance with button k.
The appliance will run at speed 2 (fast).
■ Press button + briefly. The
appliance will switch to speed 1 (slow).
■ Press button + briefly. The
appliance will switch back to speed 2
(fast).

Reversing function

ONLY MFW3X...
The reversing function is designed to
release food that has got stuck by briefly
running the worm gear in reverse. The
reversing function switches off automatically
after 15 seconds.
Caution!
– Never use the reverse function with the
grain mill attachment or the fruit press
attachment!
– Never press and hold button +
continuously while the appliance is
switched on. Only press and hold
button + continuously once the
appliance has come to a complete stop.
■ Switch the appliance off with button k
and wait until the drive has stopped.
■ Press and hold button +.
■ After approx. 5-10 seconds, release
button + and wait for the drive to
come to a standstill.
■ Switch the appliance on again with
button k.
Note: If food that has got stuck is not
released by briefly putting the appliance into
reverse, switch the appliance off, unplug
and clean it. X "Care and daily cleaning"
see page 35
02.05.2022 11:59:06 02.05.2022 11:59:06