Key Takeover Following Remote Start - ADS FLRSBA Owner's Manual

NOTE: Following an alarm event, Reservation Mode will be cancelled, and your vehicle will not remote start. To
enable remote start, the vehicle must be reset in Reservation Mode.

KEY TAKEOVER FOLLOWING REMOTE START

The 'key takeover' procedure ensures that your engine does not shut down upon entering the vehicle, during
the programmed remote start runtime. To prevent your vehicle from shutting down, complete the steps below
within the programmed delay time:
PROGRAMMED DELAY TIME
☐ Not available. Your engine will shut down upon entering the vehicle.
☐ 45 seconds
☐ 90 seconds
☐ 3 minutes
☐ 4 minutes
FOR STANDARD KEY VEHICLES
1. Unlock and enter vehicle
2. Close doors
3. Insert key into ignition and turn ignition to ON position
4. Press foot brake
FOR PUSH-TO-START VEHICLES
1. Unlock and enter vehicle with valid smartkey
2. Close doors
3. Press foot brake
NOTE: This feature may not be supported on some vehicles. If available, the programmed 'key takeover' delay
time will be communicated to you by your Flashlogic Authorized Dealer at the time of installation.
WHEN SERVICING YOUR VEHICLE
2021-10-31 © Automotive Data Solutions Inc. 4/7
FLRSBA