Key Takeover Following Remote Start; Remote Start Troubleshooting - ADS OL-RS-BA Owner's Manual

KEY TAKEOVER FOLLOWING REMOTE START

The 'key takeover' procedure ensures that your engine does not shut down upon entering the vehicle, during

the programmed remote start runtime. To prevent your vehicle from shutting down, complete the steps below

within the programmed delay time (45 seconds, 90 seconds, 3 minutes or 4 minutes):

FOR STANDARD KEY VEHICLES

1. Unlock and enter vehicle

2. Close doors

3. Insert key into ignition and turn ignition to ON position

4. Press foot brake

FOR PUSH-TO-START VEHICLES

1. Unlock and enter vehicle with valid smartkey

2. Close doors

3. Press foot brake

NOTE: This feature may not be supported on some vehicles. If available, the programmed 'key takeover' delay

time will be communicated to you by your Omegalink Authorized Dealer at the time of installation.

WHEN SERVICING YOUR VEHICLE

To ensure safety during vehicle servicing, the remote starter must be placed in 'Valet Mode'. The 'Valet Mode'

will disable remote start functionality. To activate or deactivate the 'Valet Mode', follow the instructions below:

USING THE VEHICLE KEY

1. Cycle ignition OFF/ON twice (2x) rapidly

2. Press the brake pedal three times (3x)

3. If the parking lights ﬂash once (1x), the valet mode is ON. If the parking lights ﬂash twice (2x), the valet

mode is OFF.

OL-RS-BA

Table of Contents