Table of Contents
Advertisement
WARNING! Beware of kickback when
pressing the trigger!
Operation with detergent
Detergent can only be added when the
device is operated in low pressure
mode.
DANGER
When using detergents, the material
data safety sheet issued by the
detergent manufacturer must be
adhered, especially the instructions
regarding personal protective
equipment.
Remove the cap of the clean detergent
bottle. Gently pull the onboard
detergent tank out of its storage
position.
Fill the tank with detergent designed
specifically for use with pressure
washers.
Push the detergent bottle with the
opening pointing downwards into the
connection for the hose clean
detergent.
Recommended cleaning method
• Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
• Spray off loosened dirt with the high
pressure Met.
After operation with detergent
• Remove the hose clean detergent
bottle from the intake and close it with
the lid.
• For storage, put the detergent bottle
into the retainer with the cap pointing
up.
Interrupting operation
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
• Put the trigger gun with the spray
lance into the parking position.
• During longer breaks(more than 5
minutes), also turn the appliance off
using the "OFF/ON" switch.
Finish operation
• Release the lever of the trigger gun.
• Turn off the appliance " OFF/ON".
• Disconnect the mains plug from the
socket.
Only separate the high-pressure hose
from the trigger gun or the device when
there is no pressure in the system.
TURN OFF TAP
• Pressure the lever of the trigger gun
to release any remaining pressure in
the system.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
ATTENTION
• When disconnecting the supply or
high pressure hose, warm water may
leak from the connection after
operation.
• Detach the appliance from the water
supply.
Transportation
CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during
transport.
When transporting by hand
• Switch the product off and disconnect
it from the water and power supply.
• Pull out the transport handle until it
audibly snaps into place. Attach
transportation guards, if applicable.
• Pull the appliance by its transport
handle.
When transporting in
vehicles
8
Advertisement
Table of Contents
