Table of Contents
Advertisement
Remove coupling from the water
connection, and rinse with warm water
to prevent any foreign matter from
clogging the pump.
Clean the nozzle with the needle
clean-out tool provided . Remove
the spray wand from the gun.
Remove any dirt from the nozzle
hole and rinse.
Troubleshooting
DANGER Risk of electric shook.
Turn off the appliance and remove the main plug prior to performing any care and
maintenance work. Repair work and work on the electrical components may not only
be performed by an authorized customer service. You can rectify minor faults yourself
with the help of the following overview. If in doubt, please consult the authorized
customer service.
Symptom
Machine refuses
to start
Fluctuating pressure
Machine stops
ATTENTION
• The sieve must not be damaged.
• Pull the sieve out using flat pliers.
• Clean the sieve under running water.
• Reinsert the sieve into the water
connection.
Cause
Machine not plugged in
Defective socket
Defective extension cord
Pump sucking air
Valves dirty, worn out or stuck
Pump seals worn out
Incorrect mains voltage
Thermal sensor activated
Nozzle partially blocked
10
Recommended action
Plug in machine
Try another socket.
Switch off other machines.
Try without the extension cord.
Check that hoses and
connections are airtight.
Clean and replace or refer to
local distributor
Clean and replace or refer to
local distributor
Check that the mains voltage
corresponds to specification on
the model tag.
Leave the washer for 5 minutes
to cool down. Clean the nozzle
Advertisement
Table of Contents
