Table of Contents
Advertisement
This high-pressure cleaner is suited to
work with the YILI suction hose with
backflow vale to draw in surface water,
e.g. from water butts or ponds.
Fill the suction hose with water.
Screw the suction hose into the water
connection of the appliance and insert
it into the water source (e.g. rainwater
drum).
Bleed the device as follows prior to
operation:
• Turn on the appliance "OFF/ON"
• Unlock the lever of the trigger gun.
• Push the lever of the trigger gun, the
device will switch on.
• Let the device run (max. 2 minutes)
until the water exits the trigger gun
without bubbles.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
Operation
ATTENTION
Dry running of more than 2 minutes
leads to damage of the high-pressure
pump. If the appliance does not build
up pressure within 2 minutes, switch
the appliance off and proceed in
accordance with the instructions in
Chapter "Troubleshooting"
High pressure operation
CAUTION
Keep a distance of at least 30 cm when
using the jet for cleaning painted
surfaces to avoid damage.
CAUTION
Make sure the on/off switch is set to
"OFF/O" and insert the plug into a
properly installed socket.
ATTENTION
• The washer must be used on a
secure and stable surface in a standing,
upright position
Connect the product to power and
water supply as described.
• Open the water supply
• Hold the spray gun with both hands.
• Direct the nozzle of the chosen
accessory away from you towards the
surface to be cleaned.
• Unlock the trigger and press it until a
constant amount of water flows
through the nozzle, to allow air trapped
in the hose to escape.
• Release the trigger.
• Turn on the switch "OFF(O)/ON(I)",.
• Hold the spray gun with both hands.
Direct the water jet to the object to be
cleaned and press the trigger.
Release the lever of the trigger gun;
the device will switch off again and
stop the water jet. High pressure
remains in the system.
11
Advertisement
Table of Contents
