Canon PowerShot S400 Digital Elph User Manual page 20

iiiiiiiiiiii _ _ii8¸¸iiiil ¸_|ili_i_i _ _ _ _ii¸iiiii ¸I _ _ ii_ ¸ii_!i_i ¸I_ iii i ¸i_i ¸ii_ ¸_i_i ¸ii!!_iiiiiiii!iiii!_ii ¸ii ¸iiiii_i_ ¸i ¸iiil ¸I ¸i¸i_i:_i ¸I_! !_ i_ ¸¸¸i__ii i!_i_ii_i ¸ii i_ii i_!_ !_ i ¸! iil _i_ _iili _i i li ii%?iiii_ii_!i_!!! i_!!! i_!!! i_!!! i_!!! i_!!! i _!!! !!:iiii_iiiiii%ii_i iii !i ¸
PreParing the mera
Usethe following procedures to charge the battery pack the first time you
use the camera or when the "Change the battery pack" message displays.
Battery charger model names and types vary by region,
CB-2LS CB-2LSE
Charge Indicator Charge Indicator
Insert the battery pack all the way into the battery charger as shown and
insert the charger's plug into a power outlet.
• Align the battery pack correctly with the arrows on it and the charger.
• The charge indicator will light red while the battery pack is charging. It
will change to green when the charge is complete.
• After charging, unplug the battery charger and remove the battery pack.
II
it for longer than 24 hours continuously.
discharge it before recharging. It can be recharged at any point.
• It takes approximately 130 minutes to fully charge the battery
pack from a fully discharged state (based on Canon's testing
standard). Charging it within a temperature range of 5° to 40°
C (41° to 104° F) is recommended.
• Charge times may vary according to the ambient temperature
and the battery pack's charge state.
• SeeBattery Capacity (p. 150).
• You may hear a noise during charging. This is not a malfunction.