Getting Started; Quick Set Up - PURE Evoke C-F6 Manual

Getting started

Quick set up

1
• Fit the correct pin connector to the supplied mains power adapter.
2
• Unclip the aerial and fully extend it (steps A and B).
• If you want to connect Evoke to you network using an Ethernet cable, connect an Ethernet cable
from the Ethernet port on the back of Evoke to your router (C).
• Insert the jack of the supplied mains adapter into the socket on the rear of the radio (D).
• Plug the mains adapter into the mains supply (E).
C
3
The first time you switch on Evoke you will be asked if you would like to run the setup wizard,
which will help you connect Evoke to your network. If you want to run the setup wizard now, turn
and press the Select dial to select 'Yes' and follow the prompts on screen. To set up Evoke later,
turn and press the Select dial to select 'No'.
Note: For more information on using the setup wizard see page 18.
6
B
A
Setup wizard
Start now?
YES NO
E
D