Table of Contents
Advertisement
CLEANING THE INLET HOSE AND THE VALVE FILTER
1.
1
2
3.
THE DANGERS OF FREEZING
If the machine is exposed to temperatures below
0°C, certain precautions should be taken.
•
Turn off the water supply.
•
Unscrew the inlet hose from the supply tap.
•
Select a wash programme, start the machine
and let the programme run for a short time.
•
Interrupt the programme by turning the
programme selector to
•
Place the end of inlet and drain hoses down
low, into the waste gully (floor drain) set into the
floor. Make sure that the end of the hose does
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
INTRODUCTION
Certain problems are due to lack of simple
maintenance or oversights, which can be solved
easily without calling out an engineer. Before
contacting your Authorised Service Centre, please
carry out the checks listed below.
20
3
position.
2.
4.
20°
not go below the water level in the gully's
(drain's) water tap.
•
Select the programme "Drain" and let it run until
it is finished.
•
Turn the programme selector to
When you intend to start the machine up again,
make sure that the room temperature is above
0 °C.
The appliance is only to be used and stored indoors
at normal room temperature. The manufacturer is
not responsible for any frost damage.
During machine operation it is possible that the
pilot light blinks to indicate that the machine is not
working:
•
1 flash: problem with the water supply.
•
2 flashes: problem with the water draining.
•
4 flashes: door open.
Once the problem has been eliminated, press the
button Start/Pause
after all checks, the problem persists, contact your
Authorised Service Centre.
45°
position.
to restart the programme. If
Advertisement
Table of Contents
