Drain Filter; Water Inlet Filters; Emergency Emptying Out; The Dangers Of Freezing - Zanussi F1000 Instruction Booklet

Drain filter

The drain filter collects threads and small objects
inadvertently left in the laundry. Check regularly that
the filter is clean.
Open the filter door.
Place a container under the filter and unscrew it.
Pull out the filter.
Clean the filter under a running tap, then refit it,
screwing it fully in.
Water inlet filter
If you notice that the machine is taking longer to fill,
check that the filter in the water inlet hose are not
blocked.
Turn off the water tap.
Unscrew the hose from the tap.
Clean the filter with a stiff brush.
Screw the hose back onto the tap.

Emergency emptying out

If the water is not discharged (drain filter is blocked,
filter or drain hose are clogged), proceed as follows
to empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled down;
• place a bowl on the floor under the filter;
• slightly loosen the filter to let the water come out
slowly;
• at the end screw the filter again.

The dangers of freezing

If the machine is installed in a place where the
temperature could drop below 0°C, proceed as
follows:
• Close the water tap and unscrew the water inlet
hose from the tap.
• Place the end of the drain hose and that of the inlet
hose in a bowl placed on the floor.
• Select programme DRAIN and run it until the
machine stops.
• Switch the machine OFF by depressing the
ON/OFF button.
• Screw the water inlet hose back on and put the
drain hose back in its place.
By doing this, any water remaining in the machine is
removed, avoiding the formation of ice and,
consequently, breakage of the affected parts.
When you use the machine again, make sure that
the ambient temperature is above 0°C.
17