Inspection Procedure - Brano 15-00/2,5t Operation Manual

The person responsible for safety and determined by the user must be advised of defects
detected by the inspection or recorded during the operation.

8.2 INSPECTION PROCEDURE

(1) Daily inspection (carried out by operating staff or person responsible)
Part
1. Jack function
2. Pawls function
3. Fixative parts
(2) Regular inspection (carried out by the competent person)
Part
1. Fixative parts
2. All parts
3. Label – marking of
load capacity on the
jack
4. Brake
Inspection method
Visually,
aurally
Visual inspection
when jacking up
Visual inspection of
all screws, nuts,
rivets etc.
Inspection
method
Visual inspection
of all screws, nuts,
rivets etc.
Visual inspection
Visual inspection
Jack up and lower
the load with
weight equal
approximately to
the load capacity
of the jack
Limit / criteria for
putting-out of
operation
The jack goes
hardly, stammers,
emits noise etc.
Pawls do not snap
behind dents of the
ratchet.
Faulty or missing
parts;
Released parts
Limit / criteria for
putting-out of
operation
Faulty or missing
parts;
Released parts
Outworn or
damaged parts;
Fouled and
ungreased parts
Load capacity is not
readable
When interrupting
jacking up the brake
must hold firmly the
load in each
position during
raising and lowering
12
Remedy
To clean up and
grease the jack. If
the defect will not
be removed, get the
jack repaired.
To clean up,
grease, eventually
change the spring.
Replace by new
ones;
To retighten
released parts
Remedy
Replace by new
ones;
To retighten
released parts
Replace by new
ones;
To take to parts,
clean up, grease
and again assemble
To repair or replace
by new one
If it will not be so,
ask for repair and
adjusting of the
brake