Table of Contents
Advertisement
6. If you squeeze the part in vice, use always the appropriate pads for protection of parts
surfaces.
11.4 CHECK UP
Check up, whether all disassembled parts are suitable for next use.
1. Check up, whether no parts are worn out and have no chutes or fissures.
2. Check up, whether threaded parts have not the damaged thread.
11.5 REPAIR
Outworn or damaged parts must be replaced.
Remove little burrs and scratches or other minor surface defects and flatten out with fine
grinder or abrasive cloth.
11.6 TEST
The load test must be performed at all repaired jacks by qualified person with the load
exceeding the load capacity by 10% for verification of function and brake of the jack.
12 PUTTING OUT OF OPERATION – LIQUIDATION
The jack do not contain any noxious agents, its parts are from steel and cast iron. Hand
over the jack after putting out of operation to the firm dealing with liquidation of waste
metal.
13 RELATED DOCUMENTATION
13.1 EC declaration of conformity
13.2 The Operation Manual was elaborated in accordance with following technical regulations,
technical standards and national regulations:
Ministerial order No.24/2003 of the Collection of Law as amended (EP and Council directive
•
98/37/EC)
Ministerial order No.23/2003 of the Collection of Law as amended (EP and Council directive
•
94/9/EC)
ČSN EN ISO 12100 - 1
•
ČSN EN ISO 12100 - 2
•
ČSN EN 1494
•
ČSN EN 1050
•
ČSN EN 1127 - 2
•
ČSN EN 1127 - 1
•
ČSN EN 13463 - 1
•
Regulation of CBM (Czech Bureau of Mine) No.22/89 of the Collection of Law
•
ČSN 33 2030.
•
14 FINAL REQUIREMENTS OF THE PRODUCER TO THE
CUSTOMER
Any changes of the product, eventually usage of unoriginal spare parts can be
realized only based on the approval of the producer.
When not observing this condition the producer does not guarantee safety of his
product. In this case, any producer's guarantees do not apply to the product.
15
Advertisement
Table of Contents
