Figure 3-1. Software Installation Screen - National Instruments AT-GPIB/TNT Getting Started

Chapter 3
The software installation begins with the screen shown in Figure 3-1.
The interactive installation program takes you through the necessary steps to install
the NI-488.2 software for Windows. For help during the installation, press the Help
button. You can exit the setup at any time by pressing the Exit button.
3. After the installation is complete, restart Windows.
Most applications can use the default configuration of the software. However, if you
have changed any hardware configuration settings, or if your application requires you to
change the default parameters of the NI-488.2 software, refer to Appendix B, Changing
Software Configuration Settings. Otherwise, do not change the default configuration of
the software.
When you have finished installing your software, refer to Chapter 4, Installation
Verification and Troubleshooting, for instructions on verifying the hardware and software
installation.
© National Instruments Corp.

Figure 3-1. Software Installation Screen

3-3
Software Installation
AT-GPIB/TNT for Windows Graphics