Projecting - Sony VPL-CS6 Operating Instructions Manual

Projecting

Rear remote control
detector
FREEZE
For VPL-CS6/CX6
1
Open the connector panel, plug the AC power cord into a wall outlet, then
connect all equipment.
The ON/STANDBY indicator lights in red and the projector goes into
standby mode.
2
Press the I /
The ON/STANDBY indicator lights in green and the Intelligent Auto-setup
starts. The lens protector opens, and the powered tilt adjuster rises and stops at
the previously adjusted position.
Note
When the projector is turned on, the Startup screen is projected (VPL-CX6
only).
For details on the Startup screen, see the attached "Operating Instructions for
Memory Stick".
3
Turn on the equipment connected to the projector.
Depending on the type of your computer, for example a notebook, or an all-in-
one LCD type, you may have to switch the computer to output to the projector
by pressing certain keys (e.g.,
computer's settings.
24
GB
Projecting
6
7
I / 1
MS SLIDE
KEYSTONE
INPUT APA
MENU ENTER
PIC
MUTING
1
key.
TILT
ON/STANDBY
indicators
2
For VPL-EX1
, etc.), or by changing your
/ /
,
LCD
VGA
5
4