Combined Detergent; Filling With Rinse Aid And Making The Setting - Sharp QW-GC12F492W-EU User Manual

CHAPTER -4: PREPARING THE MACHINE FOR USE
CHAPTER -4: PREPARING THE MACHINE FOR USE
Combined detergents
Combined detergents may include various properties in it. Before using the detergent, the instruction of
detergent can be observed well. Generally combined detergents produce sufficent results under certain
conditions only.
Points to consider when using this type of products:
• Check the specifications of the product whether it is combined or not.
• Check if the detergent used is appropriate for the hardness of mains water.
• Observe the instructions of products on packagings.
• Always put the tablets into the detergent compartment in the detergent dispenser.
• You need to contact the manufacturers and find out about the suitable conditions of use.
• If you use appropriate products, they ensure savings in salt and/or rinse aid consumption.
• The scope of warranty for your machine does not cover any complaints caused by the use of these types of
detergents.
Recommended usage: If you want to obtain better results while using combined detergents, add salt and rinse
aid into your machine and adjust the water hardness setting and the rinse aid setting to the lowest position.
Solubility of the tablet detergents produced by different companies can vary depending on
the temperature and time. Therefore, it is not recommended to use such detergents in short
programs. It is more suitable to use powder detergents in such programs.
Warning: Should any problem, which you have not encountered before, arise with the use of this type of
detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
• Fill the salt and rinse aid compartments.
• Adjust the water hardness setting to the highest position and run an empty-wash.
• Adjust the water hardness level.
• Make the suitable rinse aid setting.

Filling with rinse aid and making the setting

To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment with rinse aid to
the MAX level and then close the cap. Be careful not to overfill the rinse aid compartment and wipe up any
spills.
In order to change the rinse aid level, follow the below steps before turning on the machine:
• Touch the programme button and hold it down.
• Turn on the machine.
• Hold down the programme button until "rA" disappears.Rinse aid set follows water hardness set.
• The machine will display the current setting.
• Set the level by touching the programme button.
• Switch off the machine to save the setting.
The factory setting is "4".
If the dishes are not drying properly or are spotted, increase the level. If blue stains form on your dishes,
decrease the level.
Level Brightener Dose
1 Rinse-aid not dispensed
2 1 dose is dispensed
3 2 doses are dispensed
4 3 doses are dispensed
5 4 doses are dispensed
Indicator
r1 is shown on the display
r2 is shown on the display
r3 is shown on the display.
r4 is shown on the display.
r5 is shown on the display.
EN-15