Trouble-Shooting - Zte AC2791 User Manual

12. Trouble-shooting

Failures
Error occurs during
the program The setup file may be damaged.
installation.
Directly run the software before the
Data Terminal is plugged in.
The port is occupied by other
Open port failed.
applications,
terminal", or the software is already
run.
R-UIM card is not inserted.
R-UIM card is not inserted properly.
Sometimes the front side and back
No R-UIM card.
side are confused.
R-UIM card is damaged. Validate by
using a CDMA terminal.
Antenna is not connected to the
Access Box.
No signal indicated. Out of the network service area.
The antenna or RF component is
damaged.
The
connected. (It usually occurs when
the
Internet connection
immediately made after the call is
failure.
dialed.)
Poor network signal.
The
installed in current system.
The installation
Autorun function in CD-ROM is
program can't auto
disabled because of installation of
set up. (If the Data
anti-virus software in the system, or
Terminal supports
Windows Vista system itself disabled
auto setup function.)
Autorun function in CD-ROM in
default.
CD-ROM
No CD-ROM disk
disappear
ordinal in "My
installed successfully.
Computer".
The program is not yet installed, and
ZTE Corporation
CDMA2000 1X EV-DO Wireless Data Terminal User Guide
Causes
such as "Hyper
Data Terminal is being
Internet connection
program has already
will automatically
once the program
10
Please download the program on our website
WWW.ZTEMT.COM
Close the software, plug in the Data Terminal and
run it again.
Close relevant software and run the software
again.
Insert R-UIM card.
Please refer to User Guide. Properly insert R-UIM
card.
Replace R-UIM card.
Insert the antenna into the Data Terminal.
Make sure it is in the CDMA network service
area.
Replace relevant damaged parts.
is Reconnect.
View signal strength indication and check if the
antenna is properly inserted.
been Firstly remove the original program and insert the
terminal again.
Open "My Computer" to enter CD-ROM disk
ordinal, and double-click Setup.exe to install
manually.
This is normal. If you want to display CD-ROM
is disk ordinal, you could firstly remove the program
and then insert the terminal again.
Please restart your computer. Please contact your
Solutions
and reinstall it.
http://www.zte.com.cn