Table of Contents
Advertisement
Set the network parameters (phone number, username, password), work mode, etc.
After the setting, click "Apply" button to save the settings on the current interface.
Click "Default" button and then "Apply" button to restore the settings on the current
interface to factory default.
Note:
The default network setup parameters are as below. Different regions may have
different network setup parameters, so please consult your local telecom operator.
Phone: #777
User: card
Password: card
If your Data Terminal does not support some following functions, please neglect relevant
description.
Other Setting
Click "Options" to switch the interface, and you could set URL and language, etc. If
you want to use conference call, please select "Show 3 way call button during calling";
After the setting, click "Apply" button to save the settings on the current interface.
Click "Change Password" button to set lock device. The password is required when
you start the application. The setting has nothing to do with "Default" button.
Click the button "Enable Pin". PIN code is needed when the application is started. The
setting has nothing to do with "Default" button.
Click "Default" button and then "Apply" button to restore the settings on the current
interface to factory default.
Select ring tone
After clicking "Ring", you could set different ring tones for Unconditional forwarding,
No answer forwarding, Busy forwarding and Call waiting.
After the setting, click "Apply" button to save the settings on the current interface.
Click "Default" button and then "Apply" button to restore the settings on the current
interface to factory default.
Supplementary Services
After clicking "Service", you could set "Busy Forwarding", "No answer forwarding",
ZTE Corporation
CDMA2000 1X EV-DO Wireless Data Terminal User Guide
8
http://www.zte.com.cn
Advertisement
Table of Contents
