Connecting An Aerial And A Vcr; Switching On The Tv - Sony Trinitron KD-32DX100U Operating Instructions Manual

3. Connecting an aerial and a VCR

Connecting an aerial only
RF Loopthrough
cable (supplied)
Connecting an aerial and a VCR
Scart lead
(not supplied)
Rear of VCR

4. Switching on the TV

Existing aerial lead
Existing aerial lead
RF Loopthrough
cable (supplied)
RF Lead
(not supplied)
On/Off button
1 Connect your existing aerial lead to the Digital socket
marked on the rear of the TV as shown.
2 Connect the supplied RF loopthrough cable from the
sockets marked to the Analogue socket marked
.
1 Connect your existing aerial lead to the Digital socket
marked on the rear of the TV as shown.
2 Connect the supplied RF loopthrough cable from the
aerial socket marked
socket of your VCR.
3 Connect a lead from the RF output of your VCR to
the Analogue TV socket marked
4 Connect a scart lead from the scart socket marked
3/ s 3 on the rear of the TV to a scart socket on
your VCR (Refer to the VCR instructions).
5 Connect the VCR to the mains socket and switch on.
6 Insert a pre-recorded tape into the VCR and press
the 'PLAY' button. This enables the TV set to locate
and store the video channel during the 'Automatically
tuning the TV' procedure.
1 Connect the TV plug to your mains socket (220 -
240V AC, 50 Hz) and switch on.
2 Push in the On/Off button ( ) on the front of the TV.
If the red standby mode indicator on the front of the
TV is lit, press the TV
control to switch on the TV set. Please be patient as
the picture may take a few moments to appear on the
TV screen.
Getting Started
on the TV to the RF input
.
/
button on the remote
5
Getting Started