Table of Contents
Advertisement
This display shows Entry 01, Route 11as empty.
4. Press the ENTER Key
flash, use the Throttle knobs to dial up the turnout address you want
to add to the route. Use the L Throttle for 100s and the R Throttle
Knob for 10s & 1s. Once you make changes to the turnout address
number or the position of that address, the entire text area will begin
to flash. The key pad is not active during this throttle task even
though some keys may change the display.
5. When the turnout address you want is on the screen use the OPTN t
OPTN
OPTN
Key
to set the turnout to t (thrown) or the CLOC c Key
t t
set the turnout to c (closed).
This display shows Entry 01, Route 11 with turnout address 005 set for
closed. In this case address 005 is the TOP address for this route
6. If you wish to make no changes to the route and entry selected, sim-
ply press the BACK Key
turnout address/position editing and return to selecting a different
route/entry number.
7. Once your selection is complete, press the ENTER Key
the turnout address in the position selected into the route.
8. Continue entering route entries in this manner until your route is com-
plete. You can toggle back and forth between selecting route and
entry numbers and entering turnout addresses and positions by press-
ing either Throttle knob or the BACK Key
ENTER
and "Sw" in the text area will begin to
because it is Entry 01 for the Route.
BACK
or either of the Throttle knobs to exit
62
ENTER
to save
BACK
.
CLOC
CLOC
to
c c
Advertisement
Table of Contents
