Table of Contents
Advertisement
selection mode by pressing another key to begin another throttle
task. The EXIT Key can be used at any time to return to Fn mode
for normal loco operation.
5. Turn the R Throttle Knob clockwise slowly to increase the speed of
the analog locomotive. As the speed increases, the locomotive on
the track will begin to move. Your command station's TRACK STA-
TUS indicator should change color as you change the speed setting.
6. Press the R Reverse Key
ble click* the R Throttle knob to reverse the direction of the analog
loco. The R direction indicator will toggle between
The indicator will change each time you press the direction key but,
in the case of the analog loco the indicator only indicates a change
in track polarity-NOT THE ANALOG LOCO'S DIRECTION.
*To double click the throttle knob, quickly press down on the throttle
knob twice within about 1/2 second. You will hear a click each time
you press down on the throttle knob.
7. Turn the R Throttle knob counterclockwise to 0% speed to stop the
analog loco.
This illustration shows
what will be on your LCD
when you press the LOCO
Key to select an address on
the R Throttle if address
"00" was the last address
selected on the R Throttle
and where no address has
been previously selected for
the L Throttle.
As you browse through
decoder addresses, their
current status will display
on the screen.
This illustration shows the
LCD after pressing the
LOCO Key to complete the
selection process. Loco
address 00 is selected on
the R Throttle and is not
moving.
on the right side of the DT400 or dou-
R
11
and
Advertisement
Table of Contents
