Table of Contents
Advertisement
Local Stop
Press the EMRG STOP Key
DT400's display. To resume operation, use the throttle knob associ-
ated with that address to increase the loco's speed.
Press the EMRG STOP Key
with the other throttle on the DT400. To resume operation, each
operator must use their throttle to set their loco's speeds back to the
desired speed.
To stop everything on the layout, press the PWR Key
the N - Key
power off and will cause all locos to stop. Press the PWR Key
followed by Y + Key
ning again at the same speed they were running prior to STOP
mode. To exit PWR mode, press the PWR Key or the EXIT Key.
Global Stop
See Section 23.1.3 for setting the DT400 Options for Global Stop.
Press the EMRG STOP Key
To resume operations, press the PWR Key
again and the locomotives will start running again at the same
+
Y
speed they were running prior to STOP mode. To exit PWR mode,
press the PWR Key or the EXIT Key.
Turning track power off will also cause an emergency stop. Press PWR
Key followed by the N-Key to turn track power off. Press the Y+
key to turn track power back on. See section 5.2 for information on
turning track power off.
EMRG
to stop the loco that is active in the
STOP
EMRG
again to stop the loco that is associated
STOP
while the track power is on. This will turn track
N
+
again and the locomotives will start run-
Y
EMRG
to stop all locos on the layout.
STOP
PWR
followed by the Y + Key
35
PWR
followed by
PWR
Advertisement
Table of Contents
