Table of Contents
Advertisement
Remote controller
POWER OFF button
See pages E-9, E-10
VERTICAL SWING button
See page E-11
HORIZONTAL SWING button
See page E-11
HORIZONTAL SWING
ANGLE button
See page E-11
PATROLLING button
See pages E-13, E-14
How to replace batteries
1
Battery cover
How to use the remote controller
Remote controller receiver
● When batteries are low, the operation range of the remote controller may become smaller.
● Signal interference may happen when used under certain fluorescent lamps or direct sunlight.
CAUTION
● Incorrect usage of batteries may cause the remote controller to corrode due to electrolyte leakage or
explosion of the batteries.
• Do not recharge, disassemble or heat the batteries.
• When replacing the batteries, always change both and use the same type.
• If the unit will not be used for a long time, remove the batteries from the remote controller. (This is to avoid
damage due to electrolyte leakage.)
● Do not leave the remote controller in places where infants can reach. (It may cause sickness to infants due to
incorrect usage or they may swallow the batteries by accident.)
● If electrolyte leak from battery gets into your eyes or contacts with your skin or clothes, wash with sufficient
clean water immediately, and consult with a doctor if necessary.
IG-HH1A_0607.indd
8
w
You cannot start the hot air operation/foot warming operation and timers
operation with the remote controller. This is to prevent the hot fan operation from starting
due to malfunction.
Transmitter window
COOL FAN button
(blue mark)
FAN SPEED buttons
AUTO FAN SPEED button
VERTICAL DIRECTION button
ION MODE button
Remove the
battery cover.
3 m or less (Standard)
When housing the remote
controller,
insert it to the housing part at
See page E-9
the back of the main unit.
See page E-9
See page E-10
See page E-11
See page E-15
Remote controller housing part
2
Point the remote controller towards
the receiver and press the desired
button for operation.
It may not work if the pointing
direction is out of range, or there
is blocking between the transmitter
and the receiver.
E-8
Insert two batteries (AAA (R03)).
Make sure the +- polarities are
correctly aligned.
(AAA batteries DC1.5V x 2)
Do not drop or throw
the remote controller.
Do not wet the remote
controller.
2017/06/13
13:24:10
Advertisement
Chapters
Table of Contents
