How To Replace The Plasmacluster Ion Generating Unit; Specifications - Sharp IG-HH1A Operation Manual

HOW TO REPLACE THE PLASMACLUSTER
ION GENERATING UNIT
1
Power off and unplug the unit.
wStart maintenance after the unit is cooled down.
1 Remove the cover
pressing the hook
and pulling the cover
towards yourself.
2
Unit cover
1 Attach a new Plasmacluster
Ion Generating Unit to the
unit holder.
3
4
Connect the plug to start the operation, and check whether the unit replacement indicator goes off.
● After replacement, you may hear "Zi, Zi ..." sound (generated by emission of Plasmacluster ions) become
louder, however, it is normal because the Plasmacluster Ion Generating Unit has been replaced with a new
CAUTION
one. It is not a failure.
● Do not touch the connection terminal (page E-17). (Doing so could lead to failures in the unit.)

Specifications

Rated input
Dimension (mm)
Weight (kg)
Power cord length (m)
Operating mode
High density Plasmacluster 25000
applicable floor area (standard) *1
Fan speed
Power consumption (W) *2
Noise level (dB)
Timer
Safety functions
*1 The number of ions projected into every 1 cm
applicable floor area (at 1.2 m above the floor) when the product is placed close to a wall and operating at fan speed "6"
(without vertical or horizontal swing).
*2 1,270 W when operating at the highest "hot fan" speed (with vertical/horizontal swing, and the room temperature is
15°C before the Auto Fan Speed mode is reached.)
IG-HH1A_0607.indd 19
2 Pull out the unit holder
following the direction of
the arrow.
Unit holder
2 Insert the unit holder into
the main unit.
Push
Click
Hot fan mode
(10.0 m
Fan speed "6"
1,200
42
ON timer: 1, 2, 4, or 6 hour(s); OFF timer: 1, 2, 4, or 6 hour(s)
Auto-off function ● Current fuse (5 A × 2, 2.5 A × 1) ● Temperature limiter
of air is 25,000, which is measured around the center of a room with
3
E-19
3 Detach the unit from the holder by pushing
its front and back at the same time following
the direction of the arrow.
FRONT
Unit
Please do not dispose of the unit holder.
3 Attach the unit cover to the main unit.
Click
AC 220 V 50 Hz
(W) 260 x (L) 270 x (H) 720
Approx. 6.6
Approx. 1.8
)
2
Fan speed "1" Fan speed "6"
520 20
24 49
(Heat thermistor ● thermostat × 2)
Push
BACK
Push
Cool Fan mode
(13.2 m )
2
Fan speed "1"
5.5
24
2017/06/13 13:24:26