Sony Bravia KDL-40X4500 Operating Instructions Manual page 44

Auto Start-up
Power Saving
Light Sensor
Logo Illumination
Panel Key
Illumination
PC Power
Management
Language
Product Information
All Reset
Analogue Set-up
Programme List
Display
1 Digit Direct
Auto Tuning
Programme Sorting
44
GB
HDMI Device List Displays a list of connected equipment that is compatible
with control for HDMI.
~
• You cannot use "Control for HDMI" if the TV operations are linked to the
operations of an audio system that is compatible with control for HDMI.
You can run the initial set-up that appeared when you first connected the TV, and
select the language and country/area, or tune in all available channels again.
Even if you have made the settings when you first connected the TV, you may need
to change the settings after moving house, or to search for newly launched
channels.
Reduces power consumption of the TV by adjusting the backlight.
When you select "Picture Off", the picture is switched off, and the
indicator on the TV front panel lights up in green. The sound remains unchanged.
On
Automatically optimises the picture settings according to the
ambient light in the room.
Off Turns off the "Light Sensor".
~
• Do not put anything over the sensor, doing so may affect its function. See page 16
to check the position of the sensor.
Lights up and turns off the Sony logo on the front of the TV.
Constantly lights up the touch sensors on the front of the TV.
Switches the TV to standby mode when the TV receives no signal from the PC
input source for 30 seconds.
Sets the language displayed on the menu screens.
Displays product information of the TV.
Resets all settings to factory settings and displays the initial set-up screen.
~
• Do not turn off the TV or press any buttons during "All Reset" (takes about
30 seconds).
• Settings for the Digital Favourites lists, country/area, language, and auto tuned
channels will also be reset to factory settings.
Select "Off" to hide the list of analogue channels from the XMB™
(XrossMediaBar).
When "1 Digit Direct" is set to "On", you can select an analogue channel using one
preset number button (0 – 9) on the remote.
~
• When "1 Digit Direct" is set to "On", you cannot select channel numbers 10 and
above by entering two digits on the remote.
Tunes in all the available analogue channels.
You can retune the TV after moving house, or to search for newly launched
channels.
Changes the order of analogue channels stored in the TV.
1
Press F/f to select the channel you want to move to a new position, then press
.
2
Press F/f to select the new position for the channel, then press
(Picture Off)
.