Table of Contents
Advertisement
en Water softening system
Note: Set the water hardness determ-
ined on your appliance.
→ "Setting the water softening sys-
tem", Page 28
With a water hardness of 0 - 8 °E
you can dispense with special salt
and switch off the water softening
system.
→ "Switching off the water softening
system", Page 29
Setting the water softening
system
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 27
Press
.
2.
To open the basic settings, press
3.
for 3 seconds.
a The display shows H:xx.
a The display shows
Press
or
4.
right water hardness has been set.
The value H:04 is set at the fact-
ory.
To save the settings, press
5.
for 3 seconds.
Special salt
You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The amount of spe-
cial salt required depends on the wa-
1
Depending on the appliance specifications
28
.
repeatedly until the
ter hardness: the higher the water
hardness, the greater the amount of
special salt required.
ATTENTION!
¡ Detergent may damage the water
softening system.
Only fill the dispenser of the wa-
▶
ter softening system with special
dishwasher salt.
¡ Special salt can damage the tub
due to corrosion.
To make sure that any special
▶
salt that escapes is washed out
of the tub, add the special salt
to the dispenser for special salt
immediately before the pro-
gramme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
1
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
a
Advertisement
Table of Contents
