Table of Contents
Advertisement
en Troubleshooting
Fault
Detergent residue in the ap-
pliance
Water marks on plastic
parts.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
52
Cause
The lid of the detergent dis-
penser is blocked by the tab
and will not open.
Tabs are used in the quick
or short programme. Dissolv-
ing time of the tab is not at-
tained.
Washing effect and dissolv-
ing performance are re-
duced after a prolonged
storage time or detergent is
very lumpy.
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
White coating is deposited in
the appliance interior.
Special salt dispenser is not
screwed tight.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
The hardness range is set in-
correctly or the water hard-
ness is greater than 62 °E
(8,9 mmol/l).
troubleshooting
Position the tab in the detergent dis-
▶
penser crosswise, not vertically.
Select a more intensive "Pro-
▶
gramme" → Page 20 or use
"Powder detergent" → Page 31.
Change your "detergent"
▶
→ Page 31.
Select a more intensive pro-
▶
gramme.
→ "Programmes", Page 20
Position tableware at an angle.
▶
→ "Arrange tableware", Page 34
Use rinse aid.
▶
→ "Rinse aid", Page 30
Set the water softening system
▶
higher.
Change your "detergent"
▶
→ Page 31.
Clean the appliance mechanically.
▶
Set the water softening system cor-
1.
rectly.
In most cases you will need to in-
crease the setting.
Change your detergent if required.
2.
Screw the special salt dispenser
▶
tight.
Change your "detergent"
▶
→ Page 31.
Clean the appliance mechanically.
▶
Set the Water softening system to
▶
the water hardness or add special
salt.
Advertisement
Table of Contents
