Disposal Of An Exhausted Battery Pack - Yamato CD 12 L Instruction Manual

Make the setting as follows:
1 - 4 for driving small screws
5 - 7 for driving screws into soft material
8 - 10 for driving screws into soft and hard material
11 - 13 for driving screws into hard wood
14 - 16 for driving larger screws
" " for heavy drilling
6. USE THE SIGHT LIGHT
The sight light allows you to keep a clear view under less illuminated circumstances. To turn on the
light simply press the On/Off switch. When you release the On/Off switch, the light will be off.
7. SELECTING THE ACTION MODE (for drills with impact function)
Tools with impact function employ an action mode changing ring. Select one mode suitable for
your work. Turn the action mode changing ring and align the mark that you selected with the arrow
on the tool body.
Drilling mode without impact (rotating only)
Hammer drilling mode (rotating with hammering)
Screwdriving mode (rotating with clutch)
8. TRAPANATURA
When drilling hard smooth surfaces, use a center punch to mark the desired hole location. This will
prevent the drill bit from slipping off center as the hole is started. Hold the tool firmly and place the
tip of the bit at the point to be drilled. Depress the switch trigger to start the tool. Move the drill bit
into the work-piece, applying only enough pressure to keep the bit drilling. Do not force or apply
side pressure to elongate a hole.
Note: If your tool stop working when drilling a hole automatically, it's normal. This is the electrical
protection battery. Completely release the On/Off switch, the depress it to start the tool again.

9. DISPOSAL OF AN EXHAUSTED BATTERY PACK

To preserve natural resources, please recycle or dispose of batteries properly. This battery pack
contains lithium-ion batteries. Consult your local waste authority for information regarding available
recycling and/or disposal options. Discharge your battery pack by operating your drill, then remove
the battery pack from the drill housing and cover the battery pack connections with heavy duty
adhesive tape to prevent short circuit and energy discharge. Do not attempt to open or remove
any of the components.
1. Action mode changing ring
2. Adjusting ring
3. Graduation
4. Arrow
17