Daikin Altherma 3 R ECH2O User Reference Manual page 50

5 | Operation
User reference guide
50
c Smartphone + app
Configuration
To configure the Daikin Residential Controller app, follow the in-app instructions.
While doing this, the following actions and information are needed on the user
interface of the indoor unit:
D
User profile
Operation
Wireless gateway
Malfunctioning
Room
[D.1] Mode: Turn AP mode ON (= WLAN module active as access point):
1 Go to [D.1]: Wireless gateway > Mode.
2 In the Enable AP mode screen, select Yes.
[D.2] WPS: Connect the WLAN module to the router:
1 Go to [D.2]: Wireless gateway > WPS.
2 In the Connect to home network screen, select OK.
[D.3] Reboot: Reset the WLAN module:
1 Go to [D.3]: Wireless gateway > Reboot.
2 In the Reboot the gateway screen, select OK.
[D.4] Device info: Consult information about the WLAN module:
1 Go to [D.4]: Wireless gateway > Device info.
2 Read out SSID, MAC address, and Serial number.
INFORMATION
Restriction: WLAN settings are only visible when a WLAN cartridge is inserted in the
user interface.
About the WLAN cartridge
The WLAN cartridge connects the system to the internet. As user you can then
control the system via the Daikin Residential Controller app.
This needs the following components:
The Daikin Residential Controller app needs to be
installed on the user's smartphone. See:
http://www.onlinecontroller.daikineurope.com/
[D] Wireless gateway
[D.1] Mode
[D.2] WPS
[D.3] Reboot
[D.4] Device info
EBSH/X(B)11+16P30+50DF
Daikin Altherma 3 R ECH₂O
4P663484-1 – 2021.07