Table of Contents
Advertisement
Frequently Asked Questions
Problem
Power failure -Program can-
appears on the
celled
display.
12:00
appears on the
display.
Maximum operating duration
reached
appears on the
display.
Fault F32
appears on
the display.
Fault F33
appears on
the display.
and a fault code
Fault
not listed here appear
on the display.
No signal to the probe. Re-
position the probe in the
oven.
appears on the
display.
98
Possible cause and solution
There has been a brief power failure. This has caused
the current cooking process to stop.
Turn the oven off and then back on again.
Restart the cooking process.
There was a power failure for more than 150 hours.
Reset the date and time.
The oven has been operating for an unusually long
time. This has triggered the safety shut-off.
Confirm with OK.
The oven is now ready to use again.
The door lock for the Self Clean program has not locked.
Turn the oven off and then back on again. Start the
Self Clean program again.
If the message appears again, contact Miele
Customer Service.
The door lock for the Self Clean program has not
opened.
Turn the oven off and then back on again.
If the door lock still does not deactivate itself,
contact Miele Customer Service.
A fault has occurred that you cannot resolve.
Contact Miele Customer Service.
The probe is not being recognized.
Reposition the probe in the food.
If the probe is still not being recognized, the signal
has failed due to another cause.
In some cases, reception interference can even be
caused by a microwave operating in the vicinity of
the oven, because the microwave uses a similar
frequency range to that of the wireless probe.
Turn off the microwave when you are using the
wireless probe.
If the probe is still not being recognized, it is faulty.
You can purchase a new probe from your Miele
dealer or from Miele Customer Service.
Advertisement
Table of Contents
