Table of Contents
Advertisement
Installing and removing the
oven
For safety reasons, only use the oven
when it has been fully installed.
The oven requires a sufficient supply
of cool air for efficient operation. The
required supply of cool air must not
be excessively heated by other heat
sources (e.g., wood burning stoves).
The following must be observed
when installing the appliance:
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not install heat insulation strips
on the side walls of the cabinet
carcase.
Securing the oven in the housing unit
Connect the oven to the power
supply.
Use the carry handles on the side of
the housing to lift the appliance. It is a
good idea to remove the door and the
accessories before installing the
appliance. This makes the oven lighter
when you push it into the housing unit.
To remove the door, use the opener
supplied to lever the door open at the
top in the middle. You can also pull
the door open by grasping the sides
of the door with both hands and
pulling carefully until it opens.
Remove the door (see "Oven cleaning
and care – Removing the door") and
take the accessories out of the oven.
Push the oven into the housing unit
far enough for you to be able to
remove the carry handles.
Remove the carry handles (1.).
Keep the carry handles in case the
oven needs to be moved again in the
future.
Push the oven all the way into the
housing unit and align it in the center
of the unit (2.).
Reconnect the power supply to the
socket, if you have disconnected it
previously.
Select the Door sensor button to
open the door if you have not
removed it already.
2.
Installation
1.
109
Advertisement
Table of Contents
