Table of Contents
Advertisement
CDMA and GSM / UMTS Mini Card Hardware Integration Guide
Note: Contact vendors before
choosing your connectors — the
numbers included here are for
reference only. Choose
connectors that are appropriate
to your design.
10
In the event of a discrepancy in values between this guide and the Product Specification Document (PSD), the PSD takes precedence.
Antennas
•
Other accessories
•
For instructions on setting up the UDK, see PCI Express Mini
Card Dev Kit Quick Start Guide (Document 2130705).
Required connectors
When integrating these modules into your host device, you
need the following connector types:
RF cables that mate with Hirose U.FL connectors (model
•
U.FL #CL331‐0471‐0‐10). Modules include one or two
connector jacks depending on individual module support
for diversity or GPS functionality.
•
Industry‐standard mating connector for 52‐pin EDGE—
some manufacturers include Tyco, Foxconn, and Molex. For
example, the connector used on the Mini Card Dev Kit
board is a Molex 67910‐0001.
Industry‐standard USIM connector (MC8xxx only)—the
•
actual connector you use depends on how your device
exposes the USIM socket. For example, the USIM connector
used on the Mini Card Dev Kit board is an ITT CCM03‐
3518.
Guide organization
This guide includes the following sections:
Introduction
(this section)
1.
Power Interface
2.
Describes power control signals used by the module and
discusses design issues related to power supply
integration.
RF Integration
3.
(p.19)
Describes antenna connection methods and grounding issues,
RF interference and desense issues.
Host / Module Interfaces
4.
Describes the USB interface for host / module communication,
and the USIM interface for host / module integration.
Regulatory Information
5.
Describes regulatory approvals and regulatory information
requirements.
Acronyms and Definitions
6.
Lists acronyms and definitions used throughout this guide.
Index
7.
(p.121)
Proprietary and Confidential
15
(p.
)
(p.27)
(p.29)
(p.33)
2130114
Advertisement
Table of Contents
