CDMA and GSM / UMTS Mini Card Hardware Integration Guide
Note: Contact vendors before
choosing your connectors — the
numbers included here are for
reference only. Choose
connectors that are appropriate
to your design.
8
In the event of a discrepancy in values between this guide and the Product Specification Document (PSD), the PSD takes precedence.
Required connectors
When integrating these modules into your host device, you
need the following connector types:
•
RF cables that mate with Hirose U.FL connectors (model
U.FL #CL331‐0471‐0‐10). Modules include one or two
connector jacks depending on individual module support
for diversity or GPS functionality.
•
Industry‐standard mating connector for 52‐pin EDGE—
some manufacturers include Tyco, Foxconn, and Molex. For
example, the connector used on the Mini Card Dev Kit
board is a Molex 67910‐0001.
Industry‐standard USIM connector (MC87xx only)—the
•
actual connector you use depends on how your device
exposes the USIM socket. For example, the USIM connector
used on the Mini Card Dev Kit board is an ITT CCM03‐
3518.
Guide organization
This guide includes the following sections:
Introduction
(this section)
1.
Power Interface
2.
Describes power control signals used by the module and
discusses design issues related to power supply
integration.
RF Integration
3.
(p.17)
Describes antenna connection methods and grounding issues,
RF interference and desense issues.
Host / Module Interfaces
4.
Describes LED output.
Regulatory Information
5.
Describes regulatory approvals and regulatory information
requirements.
Acronyms and Definitions
6.
Lists acronyms and definitions used throughout this guide.
Index
7.
(p.33)
Note: The term "host" always refers to the host device.
Related documents
This guide deals specifically with hardware integration issues
that are unique to the MC57xx and MC87xx modules.
Proprietary and Confidential
13
(p.
)
(p.23)
(p.25)
(p.29)
2130114