Video Error Messages - Lexicon MV-5 Service Manual

MV-5 PROCESSOR
MV-5
MV-5 ERROR MESSAGES
MV-5 error messages are displayed on the OSD when certain error
conditions exist. This section explains what each of these error
messages means and how to fix each problem.

VIDEO ERROR MESSAGES

The following error messages apply specifically to video issues.
VIDEO PROCESS ERROR
This error message will display
when the incoming datastream is
at a higher resolution than the
resolution of the VIDEO OUT
p a r a m e t e r. T h e M V- 5 c a n
up-sample a lower resolution to a
higher resolution. However it can
n o t d o w n - s a m p l e t o a l o w e r
resolution setting.
To correct the problem, right click to return to the VIDEO OUT
Setup parameter and change the VIDEO OUT parameter to AUTO
or to a resolution setting that is higher than that of the incoming
datastream.
VIDEO PROCESS NOTICE
Video input resolution
can not be higher than
video output resolution
when set to FAROUDJA.
Please adjust settings.
PRESS > TO CONTINUE
13
Troubleshooting & Maintenance
VIDEO FORMAT OUTPUT
ERROR
This error message will display
when the MV-5 is connected to an
H D M I v i d e o m o n i t o r b u t t h e
VIDEO OUT parameter is set to a
resolution that is not supported by
the HDMI video monitor.
To correct the problem, right click
to return to the VIDEO OUT Setup
parameter and change the VIDEO
OUT parameter to AUTO or to a
resolution setting that is supported
by the video monitor.
HDCP VIDEO ERROR
This error message will display
when the video monitor is not
H D C P c o m p l i a n t a n d t h e
incoming datastream requires
HDCP compliance. Typically, any
HDMI source will require a HDCP
compliant video monitor.
To correct the problem, change
the incoming datastream to a
non-HDCP source or change the
video monitor to one that is HDCP
compliant.
LEXICON
VIDEO OUTPUT NOTICE
Video output resolution
not supported by HDMI
monitor. Please select
a different VIDEO OUT
resolution.
PRESS > TO CONTINUE
HDCP NOTICE
Display is not
HDCP Capable
6-7