Panasonic VDR-M30PP Service Manual page 31

Message
Disc is not formatted.
If it formats, it becomes
possible to use for camera.
However, when you record
from PC connection
terminal, please do not
format.
Format the disc now?
YES NO
Disc overheat.
Please retry later.
DPOF scenes over limit.
Cannot set DPOF scenes.
END OF DISC
End scene cannot be divided.
Error has occurred.
Error code No. ××××
Please read the manual.
Error has occurred.
Please reinsert a disc.
Error has occurred.
Please restart.
*4: The purpose of formatting DVD-R disc on VDR-M30 is to write to disc a program exclusively for camera
recording that is necessary to record images shot by camera in real time (increasing the response from
disc). When recording images that were edited using PC on DVD-R disc via the PC connection terminal,
do not format the disc: The program used exclusively for camera recording will disable normal recording.
Cause/condition for
message to appear
Appears when a brand-new DVD-R disc
was loaded.
Appears when the temperature inside
VDR-M30, or the temperature of disc, is
too high, and normal operation cannot be
executed.
Appears when the number of settable
scenes for DPOF has exceeded 999.
Appears if the disc recordable capacity
has reached the limit during recording.
Appears when the last image of scene
was selected to divide the scene: The
specifications state that dividing a scene
at its end is not possible.
Appears if the self-diagnosis function of
VDR-M30 has detected a serious problem
when power was turned on, or the same
trouble occurred three consecutive times
in modes other than recording. (4-digit
alpha-numerals showing the code of
trouble will appear in ××××.)
Appears if, when power was turned on,
the self-diagnosis function of VDR-M30
detected a slight trouble that can be
fixed: See "4-5 Self-Diagnosis Function
and Troubleshooting" for details.
Appears if, when power was turned on,
the self-diagnosis function of VDR-M30
detected a slight trouble that can be
fixed by turning power on again: See "4-5
Self-Diagnosis Function and
Troubleshooting" for details.
Troubleshooting
When recording on VDR-M30, choose
"YES" and designate it. When
recording video edited on PC
connected via the PC connection
terminal, choose "NO" and designate
it.
*4
Set the power switch to "POWER
OFF" with the disc loaded, and then
leave the VDR-M30 in a well-
ventilated place until the inside
temperature decreases.
Release unnecessary DOPF setting
on photos when newly setting DPOF.
Replace the disc.
Stop trying to divide a scene.
Take note of the 4-digit alpha-
numerals in ××××, and refer to "4-5
Self-Diagnosis Function and
Remedy".
Set the power switch to "POWER
OFF", press the DISC EJECT button,
and then reinsert the disc. After that,
set the power switch to "VIDEO" or
"PHOTO (disc)".
Set the power switch to "POWER
OFF", reconnect the AC adapter/
charger or battery, and then set the
power switch to "VIDEO" or "PHOTO
(disc)".