Starting Up - Ignition Co6z LED Flood User Manual

Starting up

5 Starting up
Connections in DMX mode
Connections in 'Master / Slave' mode
Co6z LED Zoom Flood IP65 270W RGBW
12
LED floodlight
Create all connections while the device is off. Use the shortest possible high-quality
cables for all connections. Take care when running the cables to prevent tripping
hazards.
Connect the DMX input of the device to the DMX output of a DMX controller or
another DMX device. Connect the output of the first DMX device to the input of the
second one, and so on to form a daisy chain. Always ensure that the output of the
last DMX device in the daisy chain is terminated with a resistor (110 Ω, ¼ W).
When you configure a group of devices in 'Master / Slave' mode, the first unit will
control the others. This feature is especially useful to start a show without much pro‐
gramming. Connect the DMX output of the master unit to the DMX input of the first
slave unit. Then connect the DMX output of the first slave unit to the DMX input of
the second slave unit and so on.
Please note that this device must not be connected to a dimmer.