© Panduit Corp. 2017
INTRODUCTION
The BT2HT Tool installs Panduit Pan-Steel coated and
uncoated MS Series strap and buckles in widths of 3/8" X
.015" thick (9.5mm), 1/2" X .015" thick (12.7mm); and 5/8" X
.015" and .025" thick (15.9mm).
Note: This tool is not intended for other uses such as cutting
or tensioning other types of fastening devices.
FIGURE 1
A
E
F
FIGURE 2
E-mail:
techsupport@panduit.com
MS STRAPPING TOOL OPERATION INSTRUCTIONS
B
C
D
G
H
K
I
J
BT2HT
TOOL FEATURES
A. Rear Handle
B.* Tension Pawl Release - Knob pointing towards the front
of tool for pawl engagement and to rear of tool for disen-
gagement.
C.* Anti-Backup Pawl Release - Lever up against tool for
pawl engagement and pulled down to disengage pawl.
D.* Detent Lock Pins - For controlled tension, pull both pins
forward; for manual tension, push both pins backward.
E. Cutter Handle - Cuts tie when strap is tensioned properly.
F. Cutter Blade
G. Tensioning Mandrel
H.* Tension Indicator Window - Located on the back of front
handle.
I.* Adjustment Knob - Adjust tension of strap application.
J. Tension Locking Set Screw
K. Front Handle - With ratchet controlled tensioning.
* See Page 2 for Feature Detail
TOOL OPERATION
See Steps 1 - 8 on Pages 3 and 4.
www.panduit.com
Page: 1 of 4
PA25758A01
Rev: 03 5-2017
Technical Support:
1-800-777-3300