Maintenance And Storage - PowerBase 577138 Instruction Manual

Maintenance and Storage

Cleaning
WARNING!
the power supply and let the product cool down before performing
inspection, maintenance and cleaning work!
1. Keep all safety devices, air vents and the motor housing free of dirt and
dust as much as possible. Wipe the equipment with a soft brush or
blow it with compressed air at low pressure after usage.
2. Clean the mower regularly with a soft nylon-bristled brush. Do not use
cleaning agents or solvents; these may damage plastic components.
3. Ensure that no water can seep into the device.
Blade maintenance
WARNING!
specialised workshop. If the blade is damaged or showing signs of
imbalance, it must be replaced.
Carry out the following steps to change the blade:
1. Turn the mower over and rest it carefully on its side.
2. Use safety gloves and hold the blade firmly. Turn the nut (20)
anticlockwise to remove the blade (19) (Fig. 15).
3. Install the new blade in the reverse order. Ensure that the blade is
positioned correctly and the screw tightened firmly.
4. Tighten the fastening nut. The tightening torque should be approx. 25 Nm.
WARNING!
maintenance work.
Only replace the blade with a genuine replacement blade, as this will
ensure top performance and safety under all conditions.
Always switch the product off, disconnect it from
If the blade is blunt, it can be sharpened in a
Always wear work gloves when engaging in any
23