Step 2 - Inserting Batteries Into The Remote Control; Step 3 - Demo Function; Placement Of Speakers - Panasonic SC-PM41 Operating Instructions Manual

Step 2 Step 2
- Inserting batteries into the remote control - Inserting batteries into the remote control
S S tep tep 3 3
- - DEMO function DEMO function

Placement of speakers

Placement of speakers
Speakers are designed identically so that no left or right channel orientation is necessary.
• These speakers do not have magnetic shielding. Do not place them near televisions, personal computers or other devices
easily infl uenced by magnetism.
• To avoid damage to the speakers, do not touch the speaker cones if you have taken the nets off.
Note
• Keep your speakers at least 10mm (
Use only the supplied speakers.
• The combination of the main unit and speakers provide the best sound. Using other speakers can damage the unit and
sound quality will be negatively affected.
Caution
• Use the speakers only with the recommended system. Failure to do so can damage the amplifi er and speakers,
and can cause fi re. Consult a qualifi ed service person if damage occurs or if a sudden change in performance
is apparent.
• Do not attach these speakers to walls or ceilings.
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of
time. Store in a cool, dark place.
• Do not use rechargeable type batteries.
• Mishandling of batteries can cause electrolyte leakage which can damage
items the fl uid contacts and may cause a fi re.
Do not:
• mix old and new batteries.
• use different types at the same time.
• heat or expose to fl ame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
■ Use
• Aim at the remote control sensor, avoiding obstacles, at a maximum range
of 7 m (23 feet) directly in front of the unit.
Refer to page 6 for the remote control sensor position.
When the unit is fi rst plugged in, a demonstration of its functions may be shown
on the display.
If the demo setting is off, you can show a demonstration by selecting "DEMO
ON".
Press and hold [STOP 7, –DEMO].
The display change each time the button is held down.
DEMO OFF
While in standby mode, select "DEMO OFF" to reduce power consumption.
13
/ ˝)away from the system for proper ventilation.
32
DEMO ON
5
RQT8038